Xerox WorkCentre 4118 User Manual

Xerox WorkCentre 4118 System Administration Guide Page 5-3
AppleTalk
AppleTalk Installation
Installation Procedure
There are two stages required to install the WorkCentre 4118 on an Appletalk network:
¾ Network Communication Setup
This requires the WorkCentre 4118 to be setup for Appletalk.
¾ Print Driver Installation
¾ Test Print
A test print should be submitted to ensure the WorkCentre 4118 has been
installed and configured correctly.
Network Communication Setup
This procedure is used to setup the network communication parameters of the WorkCentre
4118.
At the WorkCentre 4118, perform these steps:
HINT: Xerox CentreWare Internet Services can also be used to configure the
WorkCentre 4118, refer to the Internet Services chapter for instructions.
¾ Connect the device to the network outlet or cable.
¾ Press the [Machine Status] button.
1
2
3
¾ Press or until System
Admin Tools displays and press
[Enter].
¾ If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
System Admin Tools
[Passcode Protect]

Xerox WorkCentre 4118 Specifications

General

Print Technology	Laser
Print Speed	18 ppm
Max Print Resolution	600 x 600 dpi
Copy Speed	18 cpm
Max Copy Resolution	600 x 600 dpi
Fax Transmission Speed	33.6 Kbps
Paper Capacity	250 sheets
Functions	Print, Copy, Scan, Fax
Duplex Printing	Manual
Memory (Standard)	64 MB
Connectivity	USB 2.0
Supported Operating Systems	Windows, Mac