Xerox WorkCentre 4118

Xerox WorkCentre 4118 System Administration Guide Page 2-3
Basic Network Installation
Ethernet Port
The Ethernet port is the default interface used on the WorkCentre 4118.
NOTE: The Ethernet port cannot be disabled.
Ethernet Port Setup
If the speed setting of the Ethernet port needs to be changed perform the following steps:
¾ Connect the device to the network outlet or cable.
¾ Press the [Machine Status] button.
1
2
3
¾ Press or until System
Admin Tools displays and press
[Enter].
¾ If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
System Admin Tools
[Passcode Protect]
4
¾ Press or until Network
Setup displays and press [Enter].
System Admin Tools
[Network Setup]
5
¾ Press or until Configure
Network displays and press
[Enter].
¾ Press or until Ethernet
displays and press [Enter].
Config. Network
[Ethernet]