Xerox WorkCentre 4118

Xerox WorkCentre 4118 System Administration Guide Page 2-7
Basic Network Installation
Network Communication Setup
Automatically setting TCP/IP Addresses
At the WorkCentre 4118, perform these steps:
¾ Ensure the Ethernet Port has been configured (see “Ethernet Port” on page 2-3).
¾ Press the [Machine Status] button.
6
¾ Press or until Setup
displays and press [Enter].
¾ To enable TCP/IP, press or
until Enable displays and
press [Enter]. Otherwise select
Disable and press [Enter].
TCP/IP
[Setup]
1
2
3
¾ Press or until System
Admin Tools displays and press
[Enter].
¾ If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
System Admin Tools
[Passcode Protect]
4
¾ Press or until Network
Setup displays and press [Enter].
System Admin Tools
[Network Setup]