Xerox WorkCentre 4118

Xerox WorkCentre 4118 System Administration Guide Page 2-5
Basic Network Installation
Basic TCP/IP Settings
Before the printer can be used on the network, the TCP/IP addresses needs to be entered.
These can be entered automatically using Dynamic Host Configuration Protocol (DHCP) or
Bootstrap Protocol (BOOTP) or entered manually. To enter the addresses manually, you need
to obtain the following:
¾ TCP/IP Address
¾ Gateway Address
¾ Subnet Mask Address
¾ Primary DNS Server Address
Installation Procedure
There are three stages required to install the WorkCentre 4118 in a TCP/IP networking
environment:
¾ Network Communication Setup
This requires the WorkCentre 4118 to be setup for TCP/IP.
¾ Workstation Setup
This requires the workstations in the networking environment to be
configured to communicate with the WorkCentre 4118.
¾ Test Print
A print job should be submitted to ensure the WorkCentre 4118 has been
installed and configured correctly.