Xerox WorkCentre 4118

Xerox WorkCentre 4118 System Administration Guide Page 6-3
Advanced TCP/IP Setup
Enabling/Disabling LPR/LPD
This procedure is used to enable or disable Line Printer Remote/Line Printer Daemon (LPR/
LPD) port on the WorkCentre 4118. Once the port is enabled, you can change the LPR port
number.
To enable the LPR/LPD port, at the WorkCentre 4118, perform these steps:
¾ Ensure the basic TCP/IP settings have been made (see “Basic TCP/IP Settings” on page
2-5).
¾ Press the [Machine Status] button.
1
2
3
¾ Press or until System
Admin Tools displays and press
[Enter].
¾ If the System Admin Tools have
been passcode protected, type in
the password and press [Enter].
System Admin Tools
[Passcode Protect]
4
¾ Press or until Network
Setup displays and press [Enter].
System Admin Tools
[Network Setup]
5
¾ Press or until Configure
Network displays and press
[Enter].
Network Setup
[Config. Network]