Xerox WorkCentre 4118

Page 6-4 Xerox WorkCentre 4118 System Administration Guide
Advanced TCP/IP Setup
NOTE: While you can change the port number at which the WorkCentre 4118 will
accept LPR print jobs, it is recommended that you do this ONLY with extreme
caution as most LPR spoolers are set to send print jobs to the default port number,
515. To change Port number see “Using CentreWare Internet Services” on page 7-
3.
66
¾ Press or until TCP/IP
displays and press [Enter].
Config Network
[TCP/IP]
7
¾ Press or until Manual
displays and press [Enter].
TCP/IP
[Manual]
8
¾ Press or until LPD/LPD
displays and press [Enter].
Manual
[LPD/LPD]
9
¾ To enable or disable LPD/LPD,
press or until the
required setting, [Enable] or
[Disable] displays, enter the port
number using the keyboard and
press [Enter].
LPD/LPD
[Enable]