Xerox WorkCentre 4118

Page 5-4 Xerox WorkCentre 4118 System Administration Guide
AppleTalk
NOTE: The WorkCentre 4118 will attach itself to the default zone of the local
segment where it is connected.
¾ Install the Printer Driver (see “Printer Driver Installation” on page 5-5).
4
¾ Press or until Network
Setup displays and press [Enter].
System Admin Tools
[Network Setup]
5
¾ Press or until Configure
Network displays and press
[Enter].
¾ Press or until AppleTalk
displays and press [Enter].
Config. Network
[AppleTalk]
6
¾ To enable or disable AppleTalk,
press or until the
required setting, [On] or [Off]
displays and press [Enter].
AppleTalk
[On]
7