Xerox WorkCentre 4118

Xerox WorkCentre 4118 System Administration Guide Page 7-9
Network Installation Using Internet Services
NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.
¾ Select the [Status] tab and then select [Reset Network Controller] to enable the selections
to take effect.
¾ Continue with Test Print.
Test Print
To ensure the device has been installed on the network correctly a test print should be
submitted from a client workstation. Perform the following steps:
¾ Open a document on a client workstation.
¾ Select the WorkCentre 4118 in the Chooser as the printer to which the selected document
will be sent.
¾ Print the document on the device and verify that it prints correctly.
¾ Ensure the driver is installed on every workstation that will be sending jobs to the
WorkCentre 4118.
¾ Repeat the test for all workstations that will be sending jobs to the WorkCentre 4118.
¾ The installation process is now complete.
If the test print fails, refer to the Problem Solving chapter for trouble-shooting procedures.
8
9
1
2
3
4
5
6