Doc. 20780_03 71
DPRO Passive-Infrared (PIR) PRO Series by Xtralis Planning and Commissioning Manual
11 Normal Operation
11.1 Connection Options
11.1.1 Contacts
All detectors can be connected with potential-free contacts or open collector outputs to other
systems such as:
CCTV monitoring
A burglar alarm system or
A management system
For the purposes of alarm transmission. This universal use is also guaranteed for proprietary
systems. The detectors also provide enough space for the installation of bus connection
modules of the respective systems
11.1.2 Permanent Links
If, however, detectors are continuously connected to a control centre, connection to a PC via
interface module IFM-485-ST is required. The detector must be in software operating mode.
Advantages
A continuous operation of the detector gives the following advantages:
Remote access setting (no work on a ladder, no accidental misadjustment)
Signal monitoring/ verification
Management of up to 16 detectors with a maximum bus length of 1000 m
To Next Page
Loading...