Xtrails ADPRO PRO-18 - 13 Diagram; Terminal - Top View (All Models Except PRO-250 H); Terminal - Side View (All Models Except PRO-250 H)

105 pages

Save Page as PDF

To Next Page

To Previous Page

76 Doc. 20780_03

Planning and Commissioning Manual ADPRO Passive-Infrared (PIR) PRO Series by Xtralis

13 Diagram

13.1 Terminal – Top view (all models except PRO-250H)

13.2 Terminal – Side view (all models except PRO-250H)

Main Page

Default Chapter5
- Table of Contents5
1 General9
- Information about this Manual9
- Warranty9
- Customer Service and Product Monitoring Service9
2 Safety10
- User's Responsibility10
- Personal Requirements and Qualifications10
- Intended Use10
3 Description and Introduction11
4 Transportation, Packaging and Storage12
- Transportation12
- Packaging12
5 Planning - Notes13
- Fundamental Analysis13
- Planning - Key Points17
- Design and Choice of Detector19
- Detector Placement (Typical Design Recommendation)24
- False Alarms (According to DIN European Standard 0833-1)29
  - Causes of False Alarms29
  - No Alarm30
6 Installation32
- Detector Installation32
7 Operating Modes36
- Selectable Operating Modes36
  - Modes36
8 Commissioning38
- Walk Test38
9 Functions44
- Sensitivity Settings44
  - Sensitivity Settings - Hardware Operation (PRO-18(H), 18W(H), 30, 40, 45(H), 45D(H) Only)44
  - Sensitivity Settings - Software Operation44
- Adaptive Threshold Discrimination (ATD)45
- Vandalism Protection46
- Intelligent Digital Signal Processing47
- Internal Temperature Compensation47
- Pulse Count47
- Directional Detection48
- Mounting Height Adjustment48
- Internal Heating Device49
10 Software Installation50
- System Requirements50
- Install Software50
- Use Software59
- Uninstall Software78
11 Normal Operation79
- Connection Options79
  - Contacts79
  - Permanent Links79
12 Accessories80
- IFM-485-ST - Interface Module RS-48580
- AD 851 - Alignment Telescope80
- CT PRO2 - Wireless Walk Tester80
- ZA P-L1 - Pole-Mount Attachment81
- AD653 - Pole-Mount for PRO-250H81
- PRO-CMB-W - Cable Managed Bracket81
  - PRO-CMB-S - Tamper-Switch (PRO-CMB-S)82
13 Diagram84
- Terminal - Top View (All Models Except PRO-250H)84
- Terminal - Side View (All Models Except PRO-250H)84
14 Electrical Connections85
- Electrical Pin Assignment for Detectors85
  - All Models (Except PRO-250H)85
  - Pro-250H85
- Connection of the Interface Module IFM-485-ST85
  - A Single Detector to the Interface Module IFM-485-ST85
  - Several Detectors to the Interface Module IFM-485-ST86
15 Dimensions88
16 Model Specifications89
- Volumetric Detectors91
- Curtain Detectors (Barrier Detectors)96
17 Maintenance and Service100
- Safety100
- Environmental Protection100
- Recommendations100
18 Troubleshooting101
- False Alarms101
19 Disassembly and Disposal102
- Safety102
- Environmental Protection102
- Measures before Disassembly102
20 Product Overview103

Xtrails ADPRO PRO-18 - 13 Diagram; Terminal - Top View (All Models Except PRO-250 H); Terminal - Side View (All Models Except PRO-250 H)

Table of Contents

Related product manuals