EasyManua.ls Logo

Xtrails ADPRO PRO-18 - 12 Accessories; IFM-485-ST - Interface Module RS-485; AD 851 - Alignment Telescope; CT PRO2 - Wireless Walk Tester

Default Icon
105 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
72 Doc. 20780_03
Planning and Commissioning Manual ADPRO Passive-Infrared (PIR) PRO Series by Xtralis
12 Accessories
12.1 IFM-485-ST - Interface Module RS-485
The IFM-485-ST is an interface module which allows you to convieniently connect the RS-
485 bus of the detector to the USB or RS-232 bus of your computer or control panel.
Advantages
This product gives the following advantages:
Alarm management/ monitoring signal
Remote access to detector
Connection of up to 16 detectors to a data bus (maximum bus length including
‘stitches’: 1000 m)
For use together with security and traffic detectors from Xtralis
Requirement
PRO software (see chapter 14).
12.2 AD 851 - Alignment Telescope
This scope enables precise adjustment of the detector over denominated detection ranges of
up to 150 m.
12.3 CT PRO2 - Wireless Walk Tester
The wireless walk tester CT PRO2 enables precise adjustments of the detector over the
nominal detection range. Optical, as well as acoustic indications, plus a LED bar showing the
signal strength makes this product a ‘must have’ tool.

Table of Contents

Related product manuals