Xtrails ADPRO PRO-18 - 14 Electrical Connections; Electrical Pin Assignment for Detectors; All Models (Except PRO-250 H); Pro-250 H

Doc. 20780_03 77
A
DPRO Passive-Infrared (PIR) PRO Series by Xtralis Planning and Commissioning Manual
14 Electrical Connections
14.1 Electrical Pin Assignment for Detectors
14.1.1 All Models (except PRO-250H)
14.1.2 PRO-250H
14.2 Connection of the interface module IFM-485-ST
14.2.1 A single detector to the interface module IFM-485-ST
1. Connect the RS-485-Bus of the detector via the RJ12 test jack or A / B cables to the
interface module IFM-485-ST.
2. Then connect the interface module to a PC on which you have previously installed
PRO software via a USB or RS-232 cable.