Doc. 20780_03 51
DPRO Passive-Infrared (PIR) PRO Series by Xtralis Planning and Commissioning Manual
8. Click (Next), the following window appears:
9. Wait while the wizard searches for the update, the following window appears:
10. Click (Finish).
NOTE!
You can directly connect to the IFM-485-ST via the RS232 com.
Every time you change the communication port you are using,
you need to reconfigure its driver software.
Port number varies depending on the system you are using.
For more information on how to associate the communication port with the Software, refer to
section (10.3.2 Select Communication Port).
10.3 Use Software
As mentioned earlier, the Software helps you to optimize the settings and monitor the
detector(s) in use. After you have successfully mounted the detector and configured the
settings you need, you can start using the Software.
To Next Page
Loading...
