Xtrails ADPRO PRO-18

To Next Page

To Previous Page

Doc. 20780_03 79

DPRO Passive-Infrared (PIR) PRO Series by Xtralis Planning and Commissioning Manual

NOTE!

To prevent malfunction or destruction of equipment caused by potential

differences, make sure that GND is always connected between all detectors

and interface module IFM-485-ST.

Main Page

Default Chapter5
- Table of Contents5
1 General9
- Information about this Manual9
- Warranty9
- Customer Service and Product Monitoring Service9
2 Safety10
- User's Responsibility10
- Personal Requirements and Qualifications10
- Intended Use10
3 Description and Introduction11
4 Transportation, Packaging and Storage12
- Transportation12
- Packaging12
5 Planning - Notes13
- Fundamental Analysis13
- Planning - Key Points17
- Design and Choice of Detector19
- Detector Placement (Typical Design Recommendation)24
- False Alarms (According to DIN European Standard 0833-1)29
  - Causes of False Alarms29
  - No Alarm30
6 Installation32
- Detector Installation32
7 Operating Modes36
- Selectable Operating Modes36
  - Modes36
8 Commissioning38
- Walk Test38
9 Functions44
- Sensitivity Settings44
  - Sensitivity Settings - Hardware Operation (PRO-18(H), 18W(H), 30, 40, 45(H), 45D(H) Only)44
  - Sensitivity Settings - Software Operation44
- Adaptive Threshold Discrimination (ATD)45
- Vandalism Protection46
- Intelligent Digital Signal Processing47
- Internal Temperature Compensation47
- Pulse Count47
- Directional Detection48
- Mounting Height Adjustment48
- Internal Heating Device49
10 Software Installation50
- System Requirements50
- Install Software50
- Use Software59
- Uninstall Software78
11 Normal Operation79
- Connection Options79
  - Contacts79
  - Permanent Links79
12 Accessories80
- IFM-485-ST - Interface Module RS-48580
- AD 851 - Alignment Telescope80
- CT PRO2 - Wireless Walk Tester80
- ZA P-L1 - Pole-Mount Attachment81
- AD653 - Pole-Mount for PRO-250H81
- PRO-CMB-W - Cable Managed Bracket81
  - PRO-CMB-S - Tamper-Switch (PRO-CMB-S)82
13 Diagram84
- Terminal - Top View (All Models Except PRO-250H)84
- Terminal - Side View (All Models Except PRO-250H)84
14 Electrical Connections85
- Electrical Pin Assignment for Detectors85
  - All Models (Except PRO-250H)85
  - Pro-250H85
- Connection of the Interface Module IFM-485-ST85
  - A Single Detector to the Interface Module IFM-485-ST85
  - Several Detectors to the Interface Module IFM-485-ST86
15 Dimensions88
16 Model Specifications89
- Volumetric Detectors91
- Curtain Detectors (Barrier Detectors)96
17 Maintenance and Service100
- Safety100
- Environmental Protection100
- Recommendations100
18 Troubleshooting101
- False Alarms101
19 Disassembly and Disposal102
- Safety102
- Environmental Protection102
- Measures before Disassembly102
20 Product Overview103

Xtrails ADPRO PRO-18 - Page 87

Table of Contents

Related product manuals