3500 Flat Panel Industrial PCs
68
4. The last character of every macro is the end of the macro (EOM) and cannot be
deleted.
Copy
Copies a sequence of scan codes from the macro into memory. To select the section
to copy:
1. Place the cursor on the first character to copy. Press
F1 and select Copy.
2. Press
ENTER. Copy should still be highlighted, but the cursor will appear on the
Edit line.
3. Move the cursor on the last character to copy and press
ENTER.
The copied item does not appear on the screen until you select Paste.
Paste
Insert a sequence of scan codes (which were saved in memory using Copy) into the
macro. To paste a sequence of scan codes that were previously copied, position the
cursor where you want the text to appear and then press
F1. Select Paste and then
press
ENTER.
Codes
Displays a table of keys and their scan codes in Hex. See the Codes section later in
this chapter for a complete code listing.
Hex/Decimal
Toggles between displaying the scan codes in Hex and Decimal formats.
Insert
Toggles between insert and overtype mode.
Upload Menu
Use the Upload Menu to choose which data to load. Choices in this menu are:
Combo keypad, Version, and Exit.
Combo Keypad
Commands the keyboard controller to send its entire macro set for the keypad.
Version
Commands the keyboard controller to send its firmware revision number.
To Next Page
Loading...
