CHARGING SYSTEM
8-8
TROUBLE SHOOTING
The condenser is not being charged.
Before troubleshooting, remove the following part (s):
1. Seat
2. Air scoop (left)
1. Check the entire charging system’s
wiring.
NG
Reconnect.
OK
2. Check the rectifier/regulator.
Refer to “CHECKING THE RECTI-
FIER/REGULATOR” on page 8-43.
NG
Replace the rectifier/regulator.
OK
3. Check the stator coil.
Refer to “CHECKING THE STA-
TOR COIL” on page 8-43.
NG
Replace the stator coil.
OK
4. Check the charging system wire
harness.
Refer to “CIRCUIT DIAGRAM” on
page 8-6.
NG
Repair or replace the wire harness.
OK
Replace the condenser.
To Next Page
Loading...
