ii
Unpacking and Inspecting Your Product
Unpacking
the product
This device is a precision instrument and should be handled with care to pre-
vent damage or breakage.
After unpacking the device, verify that the following items are included:
• The converter itself
• Standard accessories
• MagneW Setting Data Sheet
• Test report
Verifying the
specifications
The specifications of this device are written on its attached identification
plate. Compare these specifications with those listed in the Appendix, "Sys-
tem Standard Specifications and Model Numbers," and verify that all specifi-
cations on the plate are correct, paying special attention to the following:
• Basic model number • Output/communications
• Power supply • Contact input/output
If you have any questions regarding the specifications of this device, contact
your nearest Yamatake Corporation office or Yamatake Corporation repre-
sentative. When making an inquiry, make sure to provide the model number
and product number of this device.
Inquiries
When storing this device before use, observe these precautions:
• Store it indoors at room temperature and humidity, in a place safe from
vibration or shock.
• Store it in the same condition as it was shipped.
When storing this device after use, follow these steps:
1. Attach the display cover, the terminal box cover, and the water-proof
gland to keep out moisture.
2. Replace the product in its original packaging.
3. Store it indoors at normal temperature and humidity and in a place safe
from vibration or shock.
Storage
precautions
To Next Page
Loading...
