19 Troubleshooting
108 YASKAWA TOEPC71061737B GA800 Drive Installation & Primary Operation
• High ambient temperatures
• Frequent starting and stopping
• Changes in the AC power supply or load
• Too much vibration or shock loading
• Dust, metal dust, salt, sulfuric acid, or chlorine atmospheres
• Unsatisfactory storage conditions
The drive has Maintenance Monitors that keep track of component wear and warn maintenance period when the
estimated performance life is approaching. This Maintenance Monitor eliminates the need to shut down the entire
system for unexpected problems.
Users can set alarm notifications to inform the maintenance periods for a specific drive component.
19 Troubleshooting
Refer to the Maintenance & Troubleshooting Manual (TOEPYAIGA8001) for more information.
If the drive or motor do not operate correctly, look at the drive keypad for fault and alarm information.
• For drive faults:
– The keypad shows the fault code.
– and ALM/ERR on the LED Status Ring illuminate continuously.
– The drive shuts off output and the fault relay output activates. The motor coasts to stop.
• For drive alarms:
– The keypad shows the alarm code.
– and ALM/ERR on the LED Status Ring flash.
– Usually, the drive will continue to operate the motor. Some alarms let you select a motor stopping method.
◆ Fault Reset
1. Remove the cause of the fault or alarm.
2. While the keypad is showing the fault or alarm code, push (RESET) or on the keypad.
◆ Fault
This section gives information about some of the causes and possible solutions of faults. You must use the Fault Reset
operation to remove the fault before you can operate the drive. Use the information in this table to remove the cause
of the fault.
Code Name Causes Possible Solutions
bAT Keypad Battery Low Voltage
The keypad battery voltage is low. Replace the keypad battery.
bCE Bluetooth Communication Fault
The smartphone or tablet with DriveWizard Mobile
installed is too far from the keypad.
Use the smartphone or tablet 10 m (32.8 ft) or nearer to the keypad.
Note:
bCE can occur when the smartphone or tablet is 10 m (32.8 ft)
or nearer to the keypad depending on the specifications of the
smartphone or tablet.
Radio waves from a different device are causing
interference with communications between the
smartphone or tablet and keypad.
Make sure that no device around the keypad uses the same radio
bandwidth (2400 MHz to 2480 MHz), and prevent radio
interference.
boL BrakingTransistor Overload Fault
The duty cycle of the braking transistor is high (the
regeneration power or repetition frequency is high).
• Install a braking unit (CDBR-series).
• Install a regenerative converter.
• Increase the deceleration time.
bUS Option Communication Error
The drive did not receive a signal from the controller. Correct wiring errors.
CE Modbus Communication Error
The communications cable wiring is incorrect. Correct wiring errors.
To Next Page
Loading...
