6 Mechanical Installation
20 YASKAWA TOEPC71061737B GA800 Drive Installation & Primary Operation
■ Install Drives Side-by-Side
Users can install drive models 2004xB to 2082xB and 4002xB to 4044xB side-by-side.
To install other drive models adjacent to each other, you must keep 30 mm (1.2 in) between each drive.
For side-by-side installation of drive models 2004xB to 2082xB and 4002xB to 4044xB, make sure that there is
sufficient space as shown in Figure 6.3. Set L8-35 = 1 [Installation Method Selection = Side-by-Side Mounting].
Derate the output current to align with the ambient temperature.
A - 50 mm (2 in) minimum
B - 30 mm (1.2 in) minimum on both
sides
C - 2 mm (0.08 in) minimum between
each drive
D - 120 mm (4.7 in) minimum above
and below
Figure 6.3 Installation Distances for Multiple Drives (Side-by-Side)
Note:
• Align the tops of drives that have different dimensions to help when you replace cooling fans.
• Remove the top protective covers of all drives when mounting UL Type 1 enclosure drives side-by-side.
Figure 6.4 Enclosed Wall-Mounted Type (UL Type 1) Installed Side-by-Side
◆ Removing/Reattaching Covers
This section gives information about how to remove and reattach the front cover and terminal cover for wiring and
inspection.
To Next Page
Loading...
