6 Mechanical Installation
YASKAWA TOEPC71061737B GA800 Drive Installation & Primary Operation 23
Remove the Front Cover
1. Remove the terminal cover, keypad, and keypad connector, then insert the end of the keypad connector that
has the tab into the keypad connector holder on the front cover.
A - Keypad
B - Keypad connector
C - Connector holder
Figure 6.9 Remove the Terminal Cover, Keypad, and Keypad Connector
2. Loosen the front cover screws.
Figure 6.10 Loosen the Front Cover Screws
3. Push on the four tabs found on each side of the front cover, then pull the front cover forward to remove it from
the drive.
A - Pull forward to remove the front
cover.
B - Unhook the tabs found on the sides
of the front cover.
Figure 6.11 Pull Forward to Remove the Front Cover
4. Remove the front cover from the drive.
Figure 6.12 Remove the Front Cover
To Next Page
Loading...
