13 European Standards
88 YASKAWA TOEPC71061737B GA800 Drive Installation & Primary Operation
Figure 13.2 Wiring Diagram for CE Low Voltage Directive Compliance
*1 Use terminals -, +1, +2, B1, and B2 to connect options to the drive.
WARNING
Sudden Movement Hazard. Make sure that the polarity is correct before you send a Run command. If the
drive incorrectly detects the polarity, the drive can rotate in the direction opposite of the Run command and cause serious
injury or death.
*2 For circuit protection, the main circuit is separated from the surface case that can touch the main circuit.
*3 The control circuit is a Safety Extra-Low Voltage circuit. Separate this circuit from other circuits with reinforced insulation. Make sure
that the Safety Extra-Low Voltage circuit is connected as specified.
To Next Page
Loading...
