YASKAWA iQpump1000 - Page 209

HOA Keypad Display Error Name
Er-08 Rated Slip Error
Cause Possible Solutions
Motor data entered during Auto-Tuning was
incorrect.
• Make sure the data entered to the T1 parameters match the information written on the motor
nameplate.
• Restart Auto-Tuning and enter the correct information.
Results from Auto-Tuning are outside the
parameter setting range or the tuning process took
too long.
• Check and correct faulty motor wiring.
• Perform Rotational Auto-Tuning.
The load was too high during rotational Auto-
tuning.
• Disconnect the motor from machine and restart Auto-Tuning. If motor and load cannot be
uncoupled make sure the load is lower than 30%.
• If a mechanical brake is installed, make sure it is fully lifted during tuning.
HOA Keypad Display Error Name
Er-09 Acceleration Error
Cause Possible Solutions
The motor did not accelerate for the specified
acceleration time.
• Increase the acceleration time (C1-01).
• Disconnect the machine from the motor if possible.
Torque limit when motoring is too low
(L7-01 and L7-02)
• Check L7-01 and L7-02 settings.
• Increase the setting.
The load was too high during Rotational Auto-
Tuning.
• Disconnect the motor from machine and restart Auto-Tuning. If motor and load cannot be
uncoupled make sure the load is lower than 30%.
• If a mechanical brake is installed, make sure it is fully lifted during tuning.
HOA Keypad Display Error Name
Er-11 Motor Speed Fault
Cause Possible Solutions
Torque reference is too high.
• Increase the acceleration time (C1-01).
• Disconnect the machine from the motor if possible.
HOA Keypad Display Error Name
Er-12 Current Detection Error
Cause Possible Solutions
One of the motor phases is missing:
(U/T1, V/T2, W/T3).
Check motor wiring and correct any problems.
The current exceeded the current rating of the
drive.
• Check motor wiring for a short between motor lines.
• Close any magnetic contactors used between motors.
• Replace the control board or the entire drive. For instructions on replacing the control board, contact
Yaskawa or your nearest sales representative.
The current is too low.
Attempted Auto-Tuning without motor connected
to the drive.
Connect the motor and restart Auto-Tuning.
Current detection signal error.
Replace the control board or the entire drive. For instructions on replacing the control board, contact
Yaskawa or your nearest sales representative.
HOA Keypad Display Error Name
Er-13 Leakage Inductance Error
Cause Possible Solutions
Drive was unable to complete tuning for leakage
inductance within 300 seconds.
• Check all wiring and correct any mistakes.
• Check the motor rated current value written on the motor nameplate and enter the correct value to
T1-04.
HOA Keypad Display Error Name
Er-17 Reverse Prohibited Error
Cause Possible Solutions
5.5 Auto-Tuning Fault Detection
YASKAWA TOEP YAIP1W 01A YASKAWA AC Drive - iQpump1000 Quick Start Guide
209
5
Troubleshooting