YASKAWA Motoman MH Series - Customer-Supplied Tooling Fixture; Figure 5-3 Mounting Holes on Faceplate MH75;150

TOOLING RECOMMENDATIONS
MH-Series Positioner Manual with MotoMount 5-2 MOTOMAN
5.1.1 Customer-supplied Tooling Fixture
The customer-supplied tooling hangs from the faceplate as it supports production
parts for welding. Customers control/change the design of tooling fixtures to match
the design of the production parts.
Recommendations
To ensure optimum performance from the customer-supplied tooling fixture,
please read the following recommendations:
• Use all bolt holes on the faceplate to mount the tooling fixture.
• Use the dowel pins.
Mounting Holes – Faceplate
The customer-supplied tooling must be designed to fit the MH-series faceplate
mounting holes. See Figure 5-3 for MH75/150 faceplate mounting hole pattern.
See Figure 5-4 for MH450 faceplate mounting hole pattern. See Figure 5-6 for
MH1000/1500/3000 faceplate mounting hole pattern.
o
Figure 5-3 Mounting Holes on Faceplate MH75/150
100.0 MM
(3.93 IN)
80.0 MM
(3.14 IN)
80.0 MM
(3.14 IN)
100.0 MM
(3.93 IN)
100.0 MM
(3.93 IN)
100.0 MM
(3.93 IN)
4 X 12 X 1.75
18 MM DEEP
2 X SLIP FIT FOR
M12 DOWEL
320.0 MM
(12.59 IN)