YASKAWA Motoman MH Series - Figure 7-2 Brush Assembly; Figure 7-3 Brush Removal MH75;150;450;1500

MAINTENANCE
MOTOMAN 7-3 MH-Series with MotoMount Positioner Manual
Figure 7-2 Brush Assembly
NOTE: When pulling the brush holder out, identify and secure the nut plate that slides in the top side of
the case.
6. Lower the case below the retaining edge, and slowly pull the brush holder out
of the housing (see Figure 7-3).
Figure 7-3 Brush Removal MH75/150/450/1500
FACE PLATE
BRUSH NUT
RETAINING
EDGE
BRUSH
VERIFY FULL
CONTACT WITH
FACEPLATE
SERVO
MOTOR
RETAINING
SCREW
FACE PLATE
HOUSING
BRUSH
HOLDER
1/4 IN. SCREW
BRUSH HOLDER
WITH BRUSH