YASKAWA Motoman MH Series - Figure 5-14 Tailstock Component Clearance - Motomount HD

TOOLING RECOMMENDATIONS
MH-Series Positioner Manual with MotoMount 5-8 MOTOMAN
Figure 5-14 Tailstock Component Clearance - MotoMount HD
Welding
NOTE: This does not apply to MotoMount HD.
For repeatability purposes, it is recommended that the tooling fixture and the
tailstock adapter are permanently affixed to each other. Do this by welding the
tailstock adapter and the tooling fixture together. This should be done after the
tooling fixture has been properly installed and has successfully completed several
duty cycles.
63.5 MM
(2.50 IN.)
DIAM. 90 MM
(3.54 IN.) THRU
TAILSTOCK
ADAPTER
31.8 MM
(1.25 IN.)
TAILSTOCK
ADAPTER
TOOLING PIN
90 MM DIAM X 40 MM DEEP
SHAFT CLEARANCE REQUIRED