YASKAWA Motoman MH Series - Figure 5-12 Tailstock Adapter - Motomount; Figure 5-13 Tailstock Adapter - Motomount HD

TOOLING RECOMMENDATIONS
MOTOMAN 5-7 MH-Series Positioner Manual with MotoMount
Tailstock Flange Specifications
Figure 5-12 shows the specifications for the tooling fixture flange that is secured to
the MotoMount tailstock adapter. Figure 5-13 shows the specifications for the
tooling fixture flange that is secured to the MotoMount tailstock adapter.
MotoMount
Figure 5-12 Tailstock Adapter – MotoMount
MotoMount HD
Figure 5-13 Tailstock Adapter – MotoMount HD
Auxiliar
y Mounting Holes – MotoMount HD
To further secure the tooling fixture, there are two auxiliary mounting holes (see
Figure 5-14) on the face of the MotoMount HD tooling adapter. These auxiliary
mounting holes are for added security only. Do not
use the auxiliary mounting
holes for the primary tooling support.
Center shaft clearance required on the tooling fixture when using auxiliary
mounting holes on the headstock are shown in Figure 5-11. Center shaft clearance
required when using auxiliary mounting holes on the tailstock are shown in Figure
5-14.
16 MM (.629 IN.)
MINIMUM
TAILSTOCK
ADAPTER
TOOLIN
G
FIXTURE
FLANGE
55 MM
(2.16 IN.)
MINIMUM
TAILSTOCK
ADAPTER
TOOLIN
G
FIXTURE
FLANGE