MAINTENANCE
MOTOMAN 7-5 MH-Series with MotoMount Positioner Manual
Figure 7-4 Brush Cable Post
4. Release the spring tensioner on the back of the brush by squeezing both black
spring levers and pulling away from the faceplate.
5. Reach in and steady the brush case with one hand.
6. Use a 7/16-in wrench to loosen and remove the two screws on top of the
housing (see Figure 7-2) that retains the case.
HEADSTOC
DRIVE ASSEMBLY
GROUND BRUSH
CABLE
To Next Page
Loading...