User Constants
10-11
10
* 1. Initial setting depends on Inverter capacity.
* 2. Setting for 200 V class Inverters. For 400 V class Inverters, double the value.
* 3. The contents is ignored if the setting is 0.0.
* 4. E1-13 will have the same value as E1-05 after autotuning.
* 5. Factory setting in the parentheses is for 3-wire sequence.
* 6. Parameter is only effective if HOA operator with LCD (JVOP-162) is used.
N3-04 High-slip braking OL time 40 s
o1-01 Monitor selection 6
o1-02 Monitor selection after powerup 1
o1-03 Frequency units of reference setting and monitor 0
o1-05 LCD Focus 3
o1-06
Monitor mode Selection
*6
0
o1-07
2nd monitor selection
*6
2
o1-08
3rd monitor selection
*6
2
o2-01 LOCAL/REMOTE key enable/disable 1
o2-02 STOP key during control circuit terminal operation 1
o2-03 User constant initial value 0
o2-04 kVA selection
0
*4
o2-05 Frequency reference setting method selection 0
o2-06 Operation selection when digital operator is disconnected 0
o2-07 Cumulative operation time setting 0 hr
o2-08 Cumulative operation time selection 0
o2-09 Initialize mode 2
o2-10 Fan operation time setting 0 hr
o2-12 Fault trace initialisation 0
02-14 Energy monitor initialize 0
o2-15 HAND key function selection 1
o3-01 Copy function selection 0
o3-02 Read permition selection 0
T1-02 Motor output power
0.40 kW
*4
T1-04 Motor rated current
1.90 A
*4
T1-06 Number of motor poles 4
Table 10.1 User Constants
No. Name
Factory
Setting
Setting
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
