4
-22
Start autotuning.
Error Displays during Autotuning
If the STOP Key is pressed during autotuning or a measurement error is detected, an error will be displayed
and autotuning will be canceled. Details on the error will be displayed on the Digital Operator. The fault con-
tact output and the alarm output will not operate.
Refer to Errors During Autotuning in Chapter 7 Troubleshooting for details.
Step Digital Operator Display
1 Press the Increment Key to access the start autotuning display.
2
Press the RUN Key to start autotuning.
Autotuning will end in 1 or 2 minutes.
3
When autotuning has been completed, press the MENU Key to change
the mode.
㻭㼡㼠㼛㻙㼀㼡㼚㼕㼚㼓
㻙㻭㻚㼀㼁㻺㻱㻙
㻼㼞㼑㼟㼟㻌㻾㼁㻺㻌㼗㼑㼥
7XQLQJ5HDG\"
㻾㼐㼥
+]$
67$57*2$/
㻙㻭㻚㼀㼁㻺㻱㻙
+]$
67$57*2$/
㻙㻭㻚㼀㼁㻺㻱㻙
+]$
㻾㼐㼥
㻾㼐㼥
㼀㼡㼚㼑㻌㻼㼞㼛㼏㼑㼑㼐㼕㼚㼓
㼀㼡㼚㼑㻌㻼㼞㼛㼏㼑㼑㼐㼕㼚㼓
Display when the autotuning
has been completed
㻟㻜㻑䡲䢙䢔䡪䡯
㻙㻭㻚㼀㼁㻺㻱㻙
+]$
㼀㼡㼚㼑㻌㻿㼡㼏㼏㼑㼟㼟㼒㼡㼘
TOE-S616-60.1.book 22 ページ ２０１７年８月４日 金曜日 午後３時４１分
To Next Page
Loading...
Need help?
General