Basic Call Features
95
You can use call pickup to answer someone elseās incoming call on your phone. The
SIP-T26P IP phone supports directed call pickup and group call pickup. Directed call
pickup is used for picking up a call that is ringing at a target phone number. Group call
pickup is used for picking up a call that is ringing at any phone number in a certain
group. The pickup group should be predefined, contact your system administrator for
more information.
You can pick up an incoming call by using the DPickup/GPickup soft key. To use call
pickup, you need to configure the call pickup code beforehand on a global or per-line
basis via web user interface.
Note
Directed Call Pickup
To enable the directed call pickup via web user interface:
1. Click on Features->Call Pickup.
2. Select Enabled from the pull-down list of Directed Call Pickup.
3. Click Confirm to accept the change.
To configure the directed call pickup code on a global basis via web user interface:
1. Click on Features->Call Pickup.
If there are many incoming calls at the same time, pressing the GPickup soft key on the
phone will pick up the call that rings first.
To Next Page
Loading...
