User Guide for the SIP-T26P IP Phone
122
To leave a voice mail:
You can leave a voice mail for someone else when he/she is busy or inconvenient to
answer the call. Follow the voice prompt from the system server to leave a voice mail,
and then hang up.
To configure voice mail access codes via phone user interface:
1. Press Menu->Message->Voice Mail->Set Voice Mail.
2. Press or to select the account which you want to set, press the 123 soft key
to select the proper input mode and then enter the voice mail access code.
3. Press the Save soft key to accept the change or the Back soft key to cancel.
Note
To listen to voice mails:
1. When the LCD screen prompts that the phone receives a new voice mail, press
or the Connect soft key to dial out the voice mail access code.
2. Follow the voice prompt to listen to your voice mails.
Note
To view voice mails via phone user interface:
1. Press Menu->Message->Voice Mail->View Voice Mail.
The LCD screen displays the amount of new and old voice mails.
2. Select an account and then press the Connect soft key to listen to voice mails.
Voice mail access codes must be predefined on the system server. Contact your
system administrator for the more information.
Before listening to the voice mails, make sure the voice mail access code has been
configured.
When all new voice mails are retrieved, the MESSAGE key LED will go out.