Advanced Phone Features
161
Procedure:
1. Press the BLF key of the monitored user which you want to transfer this call to.
Performing a Semi-attended Transfer
When the Transfer Mode via Dsskey is set to Attended Transfer and there is already an active
call on the IP phone, you can do the following:
Procedure:
1. Press the BLF key of the monitored user which you want to transfer this call to. The phone
will dial the number of the monitored user.
2. Press the BLF key of the monitored user again or Transfer (Trans) to complete the transfer
when receiving ringback.
Performing an Attended Transfer
When the Transfer Mode via Dsskey is set to Attended Transfer and there is already an active
call on the IP phone, you can do the following:
Procedure:
1. Press the BLF key of the monitored user which you want to transfer this call to. The phone
will dial the number of the monitored user.
2. Press the BLF key of the monitored user again or Transfer (Trans) to complete the transfer
after the monitored user answers the call.
Performing a New Call
When the Transfer Mode via Dsskey is set to New Call and there is already an active call on the
IP phone, you can do the following:
Procedure:
1. Press the BLF key of the monitored user you want to call.
The phone will dial the number of the monitored user. The original call is placed on hold.
Picking up an Incoming Call of the Monitored User
When the monitored user receives an incoming call, the BLF key indicator of the monitored user
will flash red (except the SIP-T48S/T48G IP phone). On the SIP-T48S/T48G IP phone, the BLF key
icon indicator of the monitored user will become and flashing. You can pick up the
incoming call by pressing the BLF key, or by pressing DPickup (if visual indication feature is
enabled). Before picking up an incoming call, make sure that the directed call pickup code has
been configured in advance.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
