Getting Started
41
Static IPv4 address is configurable via web user interface at the path Network->Basic.
Configuring the Static IPv6 Address
Procedure:
1. Navigate to Menu->Advanced (default password: admin) ->Network->WAN Port.
For the SIP-T42S/T42G/T41S/T41P/T40G/T40P IP phone, navigate to
Menu->Settings->Advanced Settings (default password: admin) ->Network->WAN
Port.
2. Select IPv6 or IPv4 & IPv6 from the IP Mode field.
3. Enter IPv6, and then select Static IP from the Type field.
For the SIP-T42S/T42G/T41S/T41P/T40G/T40P IP phone, navigate to IPv6->Static IPv6
Client.
4. Enter the desired value in the IP Address, IPv6 IP Prefix, Default Gateway, Pri.DNS and
Sec.DNS field respectively.
5. Press Save.
Static IPv6 address is configurable via web user interface at the path Network->Basic.
Registration
Generally, your system administrator will set the phone parameters beforehand, and performs
centralized deployment on all IP phones. In this case, after the phone starts up, it is ready to use
and the account has been registered already. But if the account is not registered, you should
register it manually. You can register one or multiple accounts on the IP phone.
You can configure one or multiple line keys to associate with an account. For more information,
refer to Configuring Multiple Line Keys per Account for more information.
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
