Basic Call Features
129
To un-mute the microphone while dialing:
1. Press again on the pre-dialing, dialing or calling screen.
Note
Call Hold/Resume
You can place an active call on hold. Only one active call can be in progress at any time. Other
calls can be made and received while placing the original call on hold. When you place a call on
hold, your IP PBX may play music to the other party while waiting.
To place a call on hold:
1. Press or the Hold soft key during a call.
The line key LED flashes green. The LCD screen indicates that the call is on hold.
Note
To resume a held call:
1. Press or the Resume soft key.
Multiple Calls on Hold:
If multiple calls are placed on hold, do one of the following:
- Press or to switch between the calls, and then press the Resume soft key to
retrieve the desired call.
- Press the corresponding line key to retrieve the call.
If more than two calls are on hold, a numbered prompt appears on the LCD screen, for example
“2/4”, indicating that this is the second call out of four calls.
You can also mute the microphone when the IP phone is ringing.
The phone will beep softly every 30 seconds to remind you that you still have a call on hold. The
phone ignores engaged audio device (handset or headset) and switches to Speakerphone to play
the hold tone by default. The Speakerphone key will light up for 1 second.
To Next Page
Loading...
