User Guide for the SIP-T54S Media IP Phone
154
If the call is parked successfully, you will hear a voice prompt confirming that the
call is parked. The call is parked against the extension you entered.
To retrieve a parked call in FAC mode:
1. Do one of the following:
- If the park retrieve code is not configured, dial the park retrieve code (e.g., *88).
- If the park retrieve code is configured, press the Retrieve soft key on the dialing
screen or retrieve park key (if configured) on the IP phone.
The phone will dial the configured park retrieve code and the Retrieve screen appears
as below:
2. Follow the voice prompt, do one of the following:
- Press on the phone where the call is parked.
- Enter the desired extension followed by # (e.g., 4605#) on any phone.
Note
Transfer Mode
To configure call park feature in transfer mode via web user interface:
1. Click on Features->Call Pickup.
2. Select Transfer from the pull-down list of Call Park Mode.
3. Select Enabled from the pull-down list of Call Park.
If Enabled is selected, the Park soft key will display on the LCD screen during a call, and
the Retrieve soft key will display on the dialing screen.
4. (Optional.) Enter the call park code in the Call Park Code field.
It is configured for the Park soft key. This call park code will also apply to the call park key.
5. (Optional.) Enter the park retrieve code in the Park Retrieve Code field.
You can also press the desired BLF or BLF list key to park a call or retrieve a parked call directly.
For more information, refer to Parking a Call/Retrieving a Parked Call to the Monitored User
To Next Page
Loading...
Need help?
General
Weight and Dimensions
