User Guide for the SIP-T54S Media IP Phone
168
Configuring Transfer Mode on DSS Key
When there is an active call on the IP phone, you can handle the active call differently using a
BLF key. The phone behavior depends on the configuration of transfer mode via Dsskey with the
BLF key.
To configure the transfer mode on DSS key via web user interface:
1. Click on Features->Transfer.
2. Select the desired transfer mode from the pull-down list of Transfer Mode via Dsskey.
If you select Blind Transfer, press the BLF key to blind transfer the call to the
monitored user.
If you select Attended Transfer, press the BLF key to dial out the monitored phone
number and then perform an attended or a semi-attended transfer.
If you select New Call, press the BLF key to place a new call to the monitored user.
The original call is placed on hold.
3. Click Confirm to accept the change.
Note
Using BLF Feature on the IP Phone
You can use the BLF key in the following ways:
Place a call to the monitored user.
Transfer a call to the monitored user.
Pick up an incoming call of the monitored user.
Placing a Call to the Monitored User
You can press a BLF key to dial out the monitored phone number when the monitored line is
idle.
To place a call to the monitored user when the IP phone is idle:
1. Press the BLF key.
Transfer Mode on DssKey is also applicable to BLF list feature.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
