N824 User Manual
5
10% to 90% (non-condensing)
Placement Instructions
To avoid unexpected accident, personal injury or device damage, please read the
following instructions before installing the Gateway.
1. Ambient Temperature: to avoid overheating, please do not run N824 in the place
where the ambient temperature is above 104°F (40°C ).
2. Ventilation: please make sure that the device has good ventilation around.
3. Anti-jamming: there may be some sources of interference that might affect the
normal running of the Gateway. It’s highly recommended that the device
Should be placed away from high-power radio, radar transmitters and high
frequency, and high-current devices.
Is using independent power junction box and effective anti-grid interference
measures have been taken.
4. Mechanical load: Please make sure that the device is placed steadily to avoid any
accident that might cause damage. If placed on the desktop, please ensure it is
horizontally placed.
Connect Your N824
Connection of Ethernet Ports
N824 provides one 10/100M adaptive RJ45 Ethernet LAN port.
Connect one end of a network cable to the LAN port of the N824, and the other end to
any port of company’s LAN switch/router.
Connection of FXO Ports
N824 supports 8 FXO ports.
Connect the FXO interfaces to the Public TelephoneNetwork (PSTN).
Power Connection
Connect the power cable to the N824’s powerport, and then plug the power socket
into an electrical outlet.Press the On switch to power on the N824. The device will
start booting. In the meantime, users would see that the ―POWER‖ and ―RUN‖
indicator lights turn on.
To Next Page
Loading...
Need help?
General
