iv
IM AQ1210-01EN
Contents
Conventions Used in This Manual ................................................................................................... iii
Chapter 1 Features
1.1 Overview .......................................................................................................................... 1-1
1.2 Optical Pulse Measurement (OTDR) ................................................................................ 1-6
1.3 Displaying Measured Data (OTDR) .................................................................................. 1-7
1.4 Analyzing Measured Data (OTDR) ................................................................................. 1-10
1.5 Pass/Fail Judgment (OTDR) .......................................................................................... 1-16
1.6 Utilities ............................................................................................................................ 1-17
1.7 Application ...................................................................................................................... 1-19
1.8 File Features .................................................................................................................. 1-28
1.9 System Features ............................................................................................................ 1-30
Chapter 2 Setting Up the OTDR Feature
2.1 Measurement (Measure) Conditions ................................................................................ 2-1
2.2 Analysis (ANALYSIS) Conditions ..................................................................................... 2-7
2.3 Display (OTDR) Conditions ............................................................................................ 2-13
2.4 File Conditions ................................................................................................................ 2-23
Chapter 3 Performing Real-time Measurement
3.1 Performing Real-time Measurement ................................................................................ 3-1
3.2 Measuring with Cursors .................................................................................................... 3-6
3.3 Cable Installation Completion Notification ........................................................................ 3-7
3.4 Rerouting Work............................................................................................................... 3-10
Chapter 4 Performing Averaged Measurements
4.1 Measuring in TRACE Mode .............................................................................................. 4-1
4.2 Measuring in MAP Mode .................................................................................................. 4-5
4.3 Performing Pass/Fail Judgments on Measured Results .................................................. 4-8
4.4 Saving Measured Data ................................................................................................... 4-10
Chapter 5 Analyzing Events
5.1 Analyzing in TRACE Mode ............................................................................................... 5-1
5.2 Analyzing in MAP Mode ................................................................................................. 5-13
Chapter 6 Analyzing Waveforms
6.1 Operating Cursors and Markers ....................................................................................... 6-1
6.2 Zooming In on or Out of Waveforms .............................................................................. 6-14
6.3 Displaying a Reference Trace ........................................................................................ 6-17
6.4 Analyzing Sections ......................................................................................................... 6-20
Chapter 7 Using the Utility Feature
7.1 Using the Light Source ..................................................................................................... 7-1
7.2 Using the Visible Light Source (/VLS option).................................................................... 7-6
7.3 Using the Optical Power Meter ....................................................................................... 7-10
7.4 Using the PON Power Meter (/PPM option) ................................................................... 7-23
7.5 Using the Power Checker (/PC option) .......................................................................... 7-29
7.6 Using the Fiber Inspection Probe (/FST option) ............................................................. 7-34
To Next Page
Loading...
