5-1
IM AQ1210-01EN
Analyzing Events
5
5.1 Analyzing in TRACE Mode
Procedure
Waveform Data Display
1.
Press MENU to display the MENU screen.
For details on the MENU screen, see the Getting Started Guide, IM AQ1210-02EN.
2.
Tap OTDR to display the OTDR screen.
• Switching the Display between TRACE Mode and MAP Mode
3.
Tap the TRACE/MAP button to set the data display screen to TRACE mode.
When the data display screen is in TRACE mode, the button is MAP.
• Displaying Waveform Data
4.
Press AVG. The measurement begins, and the data display screen shows the waveform.
When averaged measurement is completed, event analysis is automatically executed, and
the event analysis results are shown on the data display screen. For details on averaged
measurement, see section 4.1.
Note
If you display waveform data using the following methods, you need to manually execute event analysis. See
“Soft Key Menu (during event analysis)” explained later.
• When a real-time measurement is performed
• When waveform data (without event analysis information) is loaded from a USB memory device or
internal memory Event analysis information is not included in waveform data of real-time measurement or
waveform data of averaged measurement that is aborted in the middle of a measurement.
Displaying Event Analysis Results
Measurement reference point: S
Event No.
Event detected as the end of the optical fiber cable: E
List of events
Displayed by tapping the
List tab.
Chapter 5 Analyzing Events
To Next Page
Loading...
Need help?
General
