YOKOGAWA Centum VP - FIO Signal Cabling; FIO with KS Cable Interface Adaptor Cabling

3. Cabling
3-49
TI 33J01J10-01EN
l FIO Signal Cabling
IMPORTANT



Bind the bottom cables to the clamp bar on the channel base.
Push in the signal cables for the top node unit as far as they will go.
F030507.ai
Front
Node unit
(1)
(2)
(3)
(4)
(5)
(1): Signal Cables for
the top node unit
(5): Signal Cables for
the Bottom node unit
Cable binding
bar
Figure Signal Cabling
lFIO with KS Cable Interface Adaptor Cabling

radius of the cable.

To reserve the ventilation for I/O module,
the signal cable should not exceed the
separator at the center of cable tray.
F030508.ai
90 mm
Separator
Cable tray
Figure FIO with KS Cable Interface Adaptor Cabling
Oct. 5, 2018-00