iv
TI 33J01J10-01EN
June 2016/4th Edition
3. Cabling
Connecting Signal Cables with Pulse Input Module AAP135
Connecting Signal Cables with Pulse Input Module AAP135
(2-wire power supply type) [1k ohm was deleted]
3.7.2 Base Plate for Adaptor
n Connecting Signal Cables with A2BN3D
and Case 4]
3.7.3 Adaptors
l
n Parts Durability[ANB10 was added]
Dec. 2015/3rd Edition
1. System Installation Requirements
n Applied Standards
l EMC Conformity Standards [EAC Marking] [Standard No. was corrected]
l Standards for Hazardus Location Equipment [Standard Nos. were deleted]
l Marine Standards [Added newly]
n
1.8 Compliance with Marine Standards [DNV GL was added]
n
deleted]
3. Cabling
3.5 Connecting Signal cable
l
corrected.]
n Parts Durability [Part No. of the built-in power fuses are deleted]
l
l
l
l, ACB51
l ANB11,ANT10U
June 2015/2nd Edition
Summery - A2BN5D was added.
- Errata was corrected.
1. System Installation Requirements
n
n Applied Standards
l Safety Standards [EN 61010-2-201 and EN 61326-1 were added] [Note was
Mar. 29, 2019-00
To Next Page
Loading...
