JOHNSON CONTROLS
60
FORM 102.20-OM2
ISSUE DATE: 6/01/2015
SECTION 3 - MAINTENANCE
FIGURE 53 - SHEAVE ANGULAR MISALIGNMENT
LD165675
LUBRICATION
Verify the type of bearings before lubricating them as
shown below:
• Sealed (not to be relubricated in the eld) as
shown in Figure 54 on page 60.
• Standard Pillow Block as shown in Figure 55 on
page 60.
• Split Pillow Block as shown in Figure 57 on page
61.
1. Seal (4)
2. Housing Cap
3. Cap Bolts (2)
4. Locating Ring (2)
5. Lock Nut
6. Lock Washer
7. Tapered Sleeve
8. Bearing
9. Housing Base
FIGURE 54 - SEALED BEARING
LD16578
LD16579
FIGURE 55 - BEARING WITH SET SCREW TYPE
LOCKING DEVICE
FIGURE 56 - BEARING WITH ECCENTRIC CAM
LD06357
1
To Next Page
Loading...
