Troubleshooting
Error Messages
152
P1089083-001 ZT410 RFID Printer for Silverline Media User Guide 10/7/16
STATUS light flashing yellow
Caution • An improperly connected printhead data or
power cable can cause this error message. The
printhead may be hot enough to cause severe burns.
Allow the printhead to cool.
The printhead temperature is
approaching its lower
operating limit.
Continue printing while the
printhead reaches the correct
operating temperature. If the
error remains, the environment
may be too cold for proper
printing. Relocate the printer
to a warmer area.
The printhead data cable is not
properly connected.
Call a service technician to
hook up the printhead
properly.
The printhead has a faulty
thermistor.
Call a service technician to
replace the printhead.
The USB host port is disabled,
and a USB device was plugged
into the port.
To use the USB device, select
YES, or send the following
SGD command to the printer:
! U1 setvar
"usb.host.lock_out" "on"
There is not enough memory
to perform the function
specified on the second line of
the error message.
Free up some of the printer’s
memory by adjusting the label
format or printer parameters.
One way to free up memory is
to adjust the print width to the
actual width of the label
instead of leaving the print
width set to the default. See
Print Width on page 80.
Ensure that the data is not
directed to a device that is not
installed or is unavailable.
If the problem persists, call a
service technician.
Table 18 • Error Messages (Continued)
Display/
Indicator Lights
Possible Cause Recommended Solution
USE USB MEMORY
DEVICE?
YES NO
OUT OF MEMORY
STORING GRAPHIC
OUT OF MEMORY
STORING FORMAT
OUT OF MEMORY
STORING BITMAP
OUT OF MEMORY
STORING FONT
To Next Page
Loading...