Zebra Silverline ZT410 - Page 185

185
Specifications
General Printer Specifications
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
Communication Interfaces
(continued)
Standard
(continued)
Zebra PrintTouch/Near Field Communication (NFC)
See Using the USB Host Port and NFC Capabilities
on page 167 for more information.
Limitations and Requirements
NFC communication must be initiated by touching your
device to the appropriate location on the printer.
Connections and Configuration
Some devices may not support NFC communication
with the printer until you alter their settings.
USB 2.0 Data Interface
Limitations and Requirements
• Maximum cable length of 16.4 ft (5 m).
Connections and Configuration
No additional configuration is necessary.
Wired 10/100 Internal Ethernet Print Server
Limitations and Requirements
• The printer must be configured to use your LAN.
• A second wired print server can be installed in the
bottom option slot.
Connections and Configuration
Refer to the ZebraNet Wired and Wireless Print Servers
User Guide for configuration instructions. A copy of
this manual is available at
http://www.zebra.com/manuals.
RS-232/CCITT V.24 Serial Data Interface
• 2400 to 115000 baud
• parity, bits/character
• 7 or 8 data bit
• XON-XOFF, RTS/CTS, or DTR/DSR handshake
protocol required
• 750mA at 5 V from pins 1 and 9
Limitations and Requirements
• You must use a null-modem cable to connect to the
printer or a null-modem adaptor if using a standard
modem cable.
• Maximum cable length of 50 ft (15.24 m).
• You may need to change printer parameters to match
the host computer.
Connections and Configuration
The baud rate, number of data and stop bits, the parity,
and the XON/XOFF or DTR control must match those
of the host computer.