67
Printer Setup and Operation
Load Silverline Media and Calibrate the Printer
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
10. Rotate the printhead-open lever downward until it locks the printhead in place.
11. If you have not already done so, load ribbon in the printer. See Instructions for Loading
Ribbon on page 68.
12. Close the media door.
13. Set the printer to Tear-Off mode (for more information, see Print Mode on page 81).
14. Press PAUSE to exit pause mode and enable printing.
The printer may perform a label calibration or feed a label, depending on your settings.
15. For best results, calibrate the printer. See Calibrate the Ribbon and Media Sensors
on page 121.
16. If desired, perform the CANCEL Self Test on page 157 to verify that your printer is able to
print.
Media loading in Tear-Off mode is complete.
To Next Page
Loading...