45-16 Brakes
Brakes
45
7. Raise rear tire and remove rear WSS and set
aside.
Note: Make sure the WSS is supported and is
not straining the WSS harness.
8. Lower the rear tire carefully to keep from
damaging painted surfaces.
9. Place rag over the left side of the swingarm
between the rear sprocket and the swing arm
to protect painted surfaces.
10. Roll rear tire forward.
11. Release rear brake hose from the metal
retaining clip.
12. Position the rear brake hose on top of clip.
13. Tip the top of the rear tire to the left.
To Next Page
Loading...
