ZIV SWT - Page 116

SWT
GIGABIT/FAST ETHERNET SWITCH TYPE SWT 116/137
USER GUIDE - M0SWTA1903Iv09 - V09 March 2019
Control commands
cd Changes the active directory.
Syntax: drn /> cd name
Arguments:
name Name of the destination directory.
Observations: The destination directory must be in the current directory
or its relative route must be entered.
To activate the directory on the level immediately above
it, two dots must be entered: cd ..
When the directory is changed the prompt shows the
equipment identification letters and the name of the active
directory. Example: drn /main>.
Examples: drn /> cd main
drn /main> cd ../admin
exit This closes the connection between the computer and the equipment, and
therefore the CLI programme session.
Syntax: drn /> exit
Arguments: -
Observations: -
Example: drn /> exit
quit This closes the connection between the computer and the equipment, and
therefore the CLI programme session.
Syntax: drn /> quit
Arguments: -
Observations: -
Example: drn /> quit