Zodiac pH Link - Page 32

31
5.2.5 Programming the "TIMERS" ltraon mes
The mers are used to dene the operang duraon of the lter pump and the duraon of chlorine producon
by the appliance. They allow the user to operate the variable-speed pump for longer and at lower speeds,
without the appliance being in constant operaon during this me.
To set the me delay programme, the start and stop mes must be entered and conrmed. If no mer has
been set, ltraon and/or chlorinaon are constantly acve.
The operang mes for the ltraon system must be sucient to correctly treat the water.
Example programmes
- Filtraon me (TIMER) in the pool season for a water temperature of 26°
==> 26/2 = 13 hours of ltraon per day
- Filtraon me (HYDROX) outside of pool season (acve winterising) for a water temperature of 16°
==> 16/2 = 8 hours of ltraon per day
==> Single-speed lter pump
• There are 2 possible programmes, TIMER 1 and TIMER 2.
• Select the "TIMER" to be programmed using the buons. Press to conrm.
• Set the lter pump start me "ON" and the pump stop me "OFF" using the buons. Press
to conrm.
• Press to exit.
• When the ltraon mes have been programmed, the leer "P" is shown on the screen:
Manual acvaon of the appliance (by pressing ) has priority over the mer. If no lter pump is connected, the
appliance acvates chlorinaon only.
If a single-speed lter pump is connected, it is acvated at the same me as chlorinaon.
If a variable-speed lter pump is connected, it operates at the same me as chlorinaon at its congured speed RPM 1.
All programmes remain valid and normal operaon resumes during the next cycle.
EN