Zodiac pH Link - Page 38

37
Conguring the setpoint:
Check that the setpoint has been set to its maximum on the heang system.
Congure the desired water temperature setpoint. The default value is 28°C.This value can be set between 15 and 32
°C. In this case, the temperature sensor of the chlorinator measures the water temperature.
• Press . Browse the menu using the buons. Press to conrm.
• Depending on the heang system (in parcular when using a heat pump), there may be a delay of a few
minutes between the me the chlorinator closes the AUX2 contact to acvate the heang system and the
eecve start-up of the heang system (heat pump compressor).
• The chlorinator displays the measured water temperature:
heang stopped
heang in operaon
The water temperature is measured by the water temperature sensor of the chlorinator:
- If the measured water temperature falls below the setpoint value by 1°C or more (e.g. 28°C -1°C
= 27°C), the relay is closed to acvate the heang system.
- If the measured water temperature is equal to or greater than the setpoint value by 1°C or more
(e.g. 28°C +1°C = 29°C), the relay is opened to deacvate the heang system.
EN