NOTE:
• The F8n Pro is calibrated before being shipped new from the factory.
• After calibrating once, the result will be retained.
• If the F8n Pro is moved to and used in an extremely hot or cold location, timecode precision could change
slightly when the power is turned off. In such cases, we recommend calibrating it again.
• Calibration is not possible when “Audio Interface with Rec” is set to “On”. (→Using SD card recording and
audio interface functions at the same time (Audio Interface with Rec) )
• Calibration is only possible when “Mode” of “Start Timecode” is set to “RTC”.
• Calibration is not possible when an FRC-8 is connected. (→Using the FRC-8)
157
To Next Page
Loading...
